Skip to main content

MBTechnology offers a full line of cold adhesives, coatings and sealants to complement it’s roofing systems.

MB Roofing Adhesive

Asbestos-free, specially formulated cold process adhesive, which contains a special blend of enhancing modifiers to meet California VOC requirements. Available in 5 and 55 gallons.
MB adhesive is used with MBTechnology’s cold process systems. It can be applied with brush, roller or squeegee.
Rate of application is approximately 1-1/2 to 2 gallons/square.

Download the MBT IAC 7MBT Roofing Adhesive Technical Data Sheet

CO-24 HT Elastomeric Roof Coating

Elastomeric coating that enables the final assembly to achieve requirements set forth by California Title 24 for “Cool Roof” and qualifies for Leed Credit. Available in 5 and 55 gallons.

Download the CO-24 HT Elastomeric Roof Coating Technical Data Sheet

MB Liquid Flash™ Permanent Detail Sealant

MB Liquid Flash™ Permanent Detail Sealant is a maximum performance, high build, liquid applied waterproofing sealant. This highly flexible and seamless waterproof sealant is designed to coat, seal and protect complex details that would normally require intricate flashing systems. It is a FAST, EASY and PERMANENT way to seal base flashings, curbs, penetrations, seams, HVAC Units, tie in dissimilar surfaces, and to make all kind of repairs.
Engineered with “Green” solvent-free, moisture cure polymers, Liquid Flash™ is ideal for the contractor that demands maximum performance, ease of use and innovative technologies that benefit our workplace and our environment. Liquid Flash™ can be used in new construction as well as restoration and maintenance applications. Liquid Flash™ provides excellent adhesion to most common building materials and can be used on roof, window, door and wall applications.

Download the MBT Liquid Flash™ Technical Data Sheet
Download the MBT Liquid Flash™ Safety Data Sheet

Mechanically Attached System (MA)

MBTechnology has developed a two-ply system, whereby the first layer (a polyester reinforced membrane FT120PSA) is applied directly over the polyisocyanurate insulation without the need for protection board. This is achieved by laying the sheet dry and mechanically fastening the side and end laps (in accordance with FM requirement). The laps are then heat welded. The cap sheet is then fully adhered to the base in cold or via heat welding. The assembly has high wind uplift security and reduces the installation cost.

Download the MBT Fastening Spacing Pattern Sheet

A Full Line of Quality Roofing Products and Systems

How can we help you today?

  • Schedule a FREE roof assessment*

  • Connect with a sales representative

  • Order samples of MetalflexSBS®

*MBCare inspection is currently available for commercial buildings only.

contact-1
I'm A...